Maintenance of woodworking engraving machine


1.The brain part of the woodworking engraving machine is an electronic device, and dust from the factory will accumulate in the computer main case. Especially in summer, heat dissipation is not very good, it will be easy to burn the circuit board. In order to keep your computer running smoothly, you still need to clean it regularly.

2. Workers need to clean the lead screw, industrial control box and circuit board regularly. Workers also need to clean the work surface in time, including the guide rail and the material debris next to the guide rail, so as to be able to better carry out the operation of the equipment, to prevent the occurrence of card machine.

3. After adding oil, the machine needs to move back and forth at a slow speed, which can also better ensure that the lubricating oil can be evenly added to the guide rail and lead screw. If the machine is not used for a long time, it also needs regular refueling operation, so as to ensure the flexibility of the equipment. Because the temperature is low, the guide rail and lead screw can be added with oil, it is best to add antifreeze oil. The refueling cycle is twice a month, that is, once every two weeks.

4. The operator should pay attention to pour out the water in the water tank in time when the machine is not in use in winter to prevent the water tank and water pipe from freezing and cracking, which will affect our normal use.